Jeep Garage  - Jeep Forum banner

2014 Altitude - trailer wiring?

Tags
2014
2K views 6 replies 5 participants last post by  boredstang 
#1 ·
I recently purchased a used 2014 Altitude (loving it)!

Was walking out to the car today and saw a few wires so I peeked under the car and saw the mess in the attached photos! Assuming this is pre-wiring for a trailer hitch? Let me know if anyone can confirm this.

Secondly can someone post a picture of what this is supposed to look like under here and would anyone know where to purchase the wiring & clips to get this looking like factory again? I am planning to add in a factory hitch is it has to do with wiring for that.

Thanks for any help and guidance anyone can provide.



 
See less See more
2
#3 · (Edited)
The stock tow harness runs down the driver side and is attached to the rear bumper up high and has a round plug on it.

Unless that's a mopar tow harness added later and just ran in a different spot. I would get some electrical tape and cover up the exposed ends just in case.


Sent from my iPhone using JeepGarage
 
#5 ·
That looks like a Mickey Mouse job. Straight half ass!!!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top