Hi everyone! First time here, long time Jeep owner (Wrangler & GCs).
Just bought a new 2017 WK2 Limited. I'm having an issue with the gas mileage graph in the dash display. Most of the time it shows the graph with numbers. But some of the time it displays just the graph and no numbers. I can't figure out why and it's driving me crazy. I've tried everything I can think of and the only way it resolves itself is after a few stop/start cycles.
Does it do the same thing when you switch to the other page, with the current mpg number? (using the L/R buttons)
I just confirmed that the graph numbers appear on both pages on mine.
Mine did it again yesterday. No remote start used. But I was running on ACC for a bit after I shut it off. Started up again and the numbers on the graph were gone.
i think if it were me id live with it before i had them try find out the problem and cause more problems than you started with. id run it on the screen with the digital number.
Same think just happened to my 2017 GC and I was at dealer for oil change and mentioned it and don't know what they did but haven't had the problem since
More than likely...they reflashed the computer with the correct software as it may not have taken fully the first time. WEBINI...I would ask your dealer to do the same with yours...so you will have some peace of mind.