Jeep Garage  - Jeep Forum banner

How to check motor mounts?

7K views 5 replies 3 participants last post by  Roki303 
#1 ·
I'm getting a bit vibration when accelerating (when engine growls). I suspect motor mounts. Anybody knows how and where to check?


Sent from my iPhone using JeepGarage
 
#2 ·
There are 3 engine mounts LH, RH and a Rear Mount. Bolts are torqued to 45 Ft. lbs.
You could also check the crossmember brace 41 Ft. Lbs..
 
  • Like
Reactions: Roki303
#4 ·
I recently replaced the trans mount on my '14 with 48,000 miles on it. The rubber in the mount was torn into 3 pieces. Yes at just 48,000 miles. But mine is an Ecodiesel and I regularly tow a 6500# race car trailer.

I bought the mount from the dealer for $70 and it took less than an hour to replace it on my lift. Could have tried to get it done under the powertrain warranty but the wait for an appointment was more than a week and then I'd need to rent a car which would have cost almost as much as the part. So I just did it myself.
 
#5 ·
Pics only show you a basic drawing of the mount.
Not sure how that would help.



Sent from my iPad using JeepGarage
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top