Like some my dealer couldn't grasp the concept of reconfiguring my TPIM so I decided to fix the problem myself. I rewired the LED drivers to the window switch lights so that they are on anytime switched power is on. I took the lazy route and just shoved the wires into the connecters as a temporary fix however two months later everything works fine. I used dto.vftis.com/mopar/disclaimer.asp to find out which wires go where although it was a PITA.
The first step is removing the two fasteners holding the door panel to the door. Both fasteners are hidden behind covers which are easily pried off. The door handle fastener is a philips screw whereas the grab handle fastener is a 7mm bolt.
Next I removed the window switch assy., which can be pried out with your fingers and disconnected the wiring harness
Next I removed the door panel. This is the most difficult part. The door panel is held on by numerous friction plugs which are very stubborn the first time you remove them. I started in the lower outside corner and just kept working my way around. Quite a bit of force is needed to remove the panel.
Disconnect the connecter in the upper front corner of the panel
The backside of the driver side door panel
Now for the connections, all I did was run a jumper wire from the LED drivers to a switched power source.
On the drivers side I connected one side of my jumper to Orange/Tan wire on the 4 wire harness labeled as C302 - (DOOR_DRIVER) 4 WAY - Driver door handle lamp driver on vftis.com.
I connected the other end of the jumper to the Pink/Yellow wire on the window switch connecter labeled as SWITCH-WINDOW/DOOR LOCK-DRIVER (EXPRESS WINDOW) - LT. GRAY (DOOR_DRIVER) 14 WAY - fused run/assy. relay output on vftis.com.
I then taped both connections in place.
I repeated the process on the passenger side, connecting the Orange/LG wire on the C307 - (DOOR_PASS) 4 WAY connecter - passenger door handle lamp driver to the Orange/Tan wire on the window switch connecter labeled as SWITCH-WINDOW/DOOR LOCK-PASSENGER - GREEN (DOOR_PASS) 10 WAY - passenger window switch illumination driver.
The lighting is horrible however you can see the door handle light and some of the map pocket light.
I hope this helps and if anyone has any questions feel free to PM me.