Jeep Garage  - Jeep Forum banner

Quadralift raising

3K views 10 replies 9 participants last post by  voyagerx 
#1 ·
I don't have a quadralift failure thus I made a separate thread. Has anyone noticed there quadralift sometimes end up in the second OR1 spot without hitting the switch? It does it to me once in a blue moon and the only way I know is the evic tells me to slow down to maintain ride height. I know I'm not pressing it by accident and it's probably done it a handful of times since September. Not a huge concern just wondering if I am or am not the only one.
 
#2 ·
Mine did this one time the first week I had it right after starting the engine. It has not done it since. You say you didn't know until you got a message about the speed, but couldn't you tell by the ride. I have not really driven in OR1 but it was my understanding the ride is a lot stiffer.
 
#3 ·
It's happen so quick I'm not in OR1 long enough to notice I think it's like 30 or 35 and it drops you back down, so that's just a quick acceleration getting onto a road from a parking lot etc it's not prolonged driving.
 
#5 ·
That's what I always tell myself until a couple days ago I couldn't blame it on the passenger as there was none! I need a 100% confirmation it's not user defined so I'll keep waiting it out and try to catch it in the act. :lol:
 
#7 ·
I'm fairly sure mine did this last night (1 week old w/ 600 miles). Noticed the message telling me to slow down to maintain ride height and realized it was in OR1. No passenger in the Jeep, and I'm positive that I didn't hit the QL button.
 
#8 ·
Mine has done it once when the car was about three months old with 3800 miles on it. I can't be sure if my wife touched the button or not as she was in the passenger seat, but she swears that she didn't touch it, so I gotta believe her.
 
#10 ·
Mine did it once, after a restart with the vehicle at an acute angle (on a steep slope) The front was higher than on flat ground and the system raised the rear to compensate then switched into OR1 mode. I pushed the down button and it lowered. When I backed out onto the flat ground the front raised about 1/2" since it was now a bit too low. My Touareg and Cayenne did almost the same thing on this same driveway. If I lower it to entry height before the shut it off it doesn't do it.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top