Go Back   Jeep Garage - Jeep Forum > Jeep Platform Discussion > Grand Cherokee - WK2 - > Trouble Shooting/Problems/Service

Join Jeep Garage Today
Reply
 
Thread Tools Display Modes
 
  #1  
Old 02-14-2013, 04:37 PM
Member
My Jeep: 2011 3.6L WK2
 
Join Date: Feb 2013
Location: Louisiana
Posts: 83
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 1150785
MrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond repute
Garage
Replacing an OEM Fog Light... PLEASE HELP!!!

Hello all! I am new to the forum after being a long time reader. I have a 2011 Laredo X with a few upgrades. So far I have figured out a lot on my Jeep by myself but I cannot figure out how to swap out my burnt fog light! It seems impossible. Again all I need to do is remove the old one and put in the new OEM replacement part. Please help with instructions! Thanks so much!
__________________

__________________
Reply With Quote
  #2  
Old 02-14-2013, 05:39 PM
antsjeep's Avatar
Member
My Jeep: 2008 3.7L WK
 
Join Date: Feb 2010
Location: Long Island, NY
Posts: 760
Thanks: 0
Thanked 12 Times in 10 Posts
Rep Power: 8585
antsjeep has a reputation beyond reputeantsjeep has a reputation beyond reputeantsjeep has a reputation beyond reputeantsjeep has a reputation beyond reputeantsjeep has a reputation beyond reputeantsjeep has a reputation beyond reputeantsjeep has a reputation beyond reputeantsjeep has a reputation beyond reputeantsjeep has a reputation beyond reputeantsjeep has a reputation beyond reputeantsjeep has a reputation beyond repute
Re: Replacing an OEM Fog Light... PLEASE HELP!!!

check this section of the forums, its dedicated to your series GC:

Grand Cherokee - WK2 - Jeep Garage - Jeep Forum
__________________

__________________
2008 WK Laredo 4x4
RC 2.5" Lift, Bilstein HD, Monroe LL, 265/70/17 General Grabber AT2, JK Moabs, 1.25" spacers, K&N 57 Series, PW Mod,
DDM 5k Lows, VLED 6K LED Fogs, Stillen Covers, 15% front tint, BA System, Infinity 3.5" dash, JL Audio 250/1 & StealthBox
Reply With Quote
  #3  
Old 02-14-2013, 07:27 PM
Member
My Jeep: 2011 3.6L WK2
 
Join Date: Feb 2013
Location: Louisiana
Posts: 83
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 1150785
MrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond reputeMrIncrediBill has a reputation beyond repute
Garage
Ya I looked high and low as best I could still haven't found anything. Help is appreciated!
__________________
Reply With Quote
  #4  
Old 02-14-2013, 08:06 PM
jacko15's Avatar
Premium Member
My Jeep: 2014 3.6L WK2
 
Join Date: Feb 2013
Location: Pennsylvania's North Shore
Posts: 1,929
Thanks: 201
Thanked 132 Times in 107 Posts
Rep Power: 88263
jacko15 has a reputation beyond reputejacko15 has a reputation beyond reputejacko15 has a reputation beyond reputejacko15 has a reputation beyond reputejacko15 has a reputation beyond reputejacko15 has a reputation beyond reputejacko15 has a reputation beyond reputejacko15 has a reputation beyond reputejacko15 has a reputation beyond reputejacko15 has a reputation beyond reputejacko15 has a reputation beyond repute
Re: Replacing an OEM Fog Light... PLEASE HELP!!!

From the owners manual:
"Front Fog Lamps
1. Reach through the cutout in the splash shield and
disconnect the wiring harness from the fog lamp
connector.
2. Firmly grasp the bulb by the two latches and squeeze
them together to unlock the bulb from the back of the
front fog lamp housing.
3. Pull the bulb straight out from the keyed opening in
the housing.
CAUTION!
• Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If
the bulb comes in contact with any oily surface,
clean the bulb with rubbing alcohol.
• Always use the correct bulb size and type for
replacement. An incorrect bulb size or type may
overheat and cause damage to the lamp, the socket
or the lamp wiring.
4. Align the index tabs of the front fog lamp bulb with
the slots in the collar of the bulb opening on the back
of the front fog lamp housing.
5. Insert the bulb into the housing until the index tabs are
engaged in the slots of the collar.
6. Firmly and evenly push the bulb straight into the lamp
housing until both tabs snap firmly into place and are
fully engaged.
7. Connect the wiring harness to the front fog lamp
connector."
__________________
Reply With Quote
  #5  
Old 02-14-2013, 08:30 PM
ColdCase's Avatar
Senior Member
 
Join Date: Apr 2011
Posts: 1,445
Thanks: 0
Thanked 26 Times in 25 Posts
Rep Power: 26319
ColdCase has a reputation beyond reputeColdCase has a reputation beyond reputeColdCase has a reputation beyond reputeColdCase has a reputation beyond reputeColdCase has a reputation beyond reputeColdCase has a reputation beyond reputeColdCase has a reputation beyond reputeColdCase has a reputation beyond reputeColdCase has a reputation beyond reputeColdCase has a reputation beyond reputeColdCase has a reputation beyond repute
Re: Replacing an OEM Fog Light... PLEASE HELP!!!

In the interior/exterior/visual section there are a few threads discussing LED replacements with bulb replacement tips and tricks... like this one:

fog led

There are better instructions before...
__________________
2011 WK2 Overland Mineral Gray/Black, Advanced warning, V8; 2009 KK Rocky Mtn V6; 2000 WJ Laredo I6; 1979 CJ7 I6... green... miles of smiles :)
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
OEM Fog Light replacement idea Todd3.6 Interior/Exterior/Visual 39 09-06-2013 11:05 AM
WK oem fog light wire short DanD2124 Troubleshooting/Problems 6 10-11-2012 09:34 PM
OEM Fog Light Installation question beto4632 Interior/Exterior/Visual 3 10-10-2012 01:22 PM
Fog Light OEM Socket pigtail gtj105 Tech Tips/DIY/How To 1 05-23-2011 09:30 AM

Powered by vBadvanced CMPS v3.2.3

All times are GMT -5. The time now is 03:01 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community