Originally Posted by DSM517
I have a 2014 Overland and just had the oil changed on it for the first time at the local Valvoline. Neither the tech nor myself could figure out how to reset the oil level to 100%. How do you reset the level? Is it the same way as the 2011-2013, by pumping the gas while in accessory mode?
Sent from my iPhone using JeepGarage
The answer is in The Fine Owners Manual
Unless reset, this message will continue to display each
time you turn the ignition switch to the ON/RUN position
or cycle the ignition to the ON/RUN position if equipped
with Keyless Enter-N-Go™. To turn off the message temporarily,
press and release the OK button. To reset the oil
change indicator system (after performing the scheduled
maintenance) refer to the following procedure.
Vehicles Equipped With Keyless Enter-N-Go™
1. Without pressing the brake pedal, press the ENGINE
START/STOP button and cycle the ignition to the
ON/RUN position (do not start the engine.)
2. Fully depress the accelerator pedal, slowly, three times
within 10 seconds.
3. Without pressing the brake pedal, press the ENGINE
START/STOP button once to return the ignition to the
NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary, repeat this procedure.