DSlide - I was checking out your photo album and I was wondering, in photos 006 and "side after", you're at the same angle as in photos 013 and 017. Your Jeep looks so much different. Is the only difference the addition of the spacers? Are you at a different ride height in those photos? Man, I'm hoping that I get that kind of milage out of my BORAs. Keep in mind I don't have the adjustable ride height.
Any chance you could take a measurement from the ground to the front and then rear fender tops in normal ride height? I'm wondering if they're the same as mine. It might convince me to upgrade to the Overland 20's and Terra Grapplers.
Bump. How about some reports on how things are going for those that bought spacers.
Any issues? Wobbles? Bolts need re-tightening?
I have been running them for 4000mi No issues at all Keep in Mind that thease are 1.25 BORA's And not off the wall brand !
I checked the torque after a few hundred mi and all was good I am Over due to recheck Soon
89 Modified wrangler to 95 Modified cherokee to 01 GC modified to 07 JK 4 DOOR X And now starting All Over Again with a stock 12 JGC WK2 limited
The Following User Says Thank You to JMP8562 For This Useful Post:
I have a new set of ALL 4 1 inch thick spacers from MOTORSPORT TECH, BORA spacers, not used.. these do not fit the OE 20 inch 10 spoke wheels, no pockets in wheels for the stud. I do not want to cut the studs. so I would like to sell for 210.00 shipped to you. all are black powder coated.
Wait, so these won't work on the Altitude wheels either (also the 20" 10 spoke, just painted black)?