Jeep Garage  - Jeep Forum banner

Lifting my WK2 on 2012 SRT8 20x10 wheels

Tags
2012 srt srt8 wk2
5K views 7 replies 4 participants last post by  RedDragon 
#1 · (Edited)
Hey everyone I just got lucky with a killer deal on a set of genuine SRT8 wheels. Pretty stoked that I found them for only $750 on craigslist. There are a couple curb marks but not enough to bother me for that price and the plans of lifting it. I also just ordered my RRO lift kit for it but i am wondering what size tires I can run. Does anyone know the offset of these wheels? I plan on running Nitto Terra Grapplers however most of you run 275/55/20 which i think is going to be a bit narrow on 10" wheels. Will I be able to fit 285/55/20s or am i going to have a lot of rubbing? I am hoping the SRT8 offset will push them out enough to allow for the larger tire option.

 
See less See more
1
#3 ·
the offset is +54 I believe. It should be stamped on the rear of each wheel.

285/55 should be ok. Check the tire calculators and see what the difference is gonna be.
 
#4 ·
Thank you Scott,
Well the 275/55/20 would measure 31.91" tall and 10.83" wide.
And the 285/55/20 would measure 32.34" tall and 11.22" wide.
I would love to run the 285s but I definitely dont want any rubbing. I would like to have a small poke from the tires will the 54 mm offset stick them out a bit or will I want to be running spacers as well?
 
#5 ·
You MAY be able to get away with the 285-55 since its only 11.22" wide. I tried a 305-40/22 on my SRT(12.01" wide) ad it barely touched at full lock and suspension completely compressed. The +54 does push the wheels out a little more.
 
#7 ·
Ciao,

I owned a Set of EtaBeta Jofiel wheels in the same size like your SRT wheels.

You can mount the same tire size like the SRT, that means 295/45 20 without any doubt.

By the way... the offset is 50, that one of the regular Jeep wheels is normaly 57.

Good luck and don't forget the pictures :)

-Gigi
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top