About once or twice a week, my QuadraLift never stops blinking "Raising" or Lowering". If it's lowering to the "Entry" position and continues to blink, I push the up button, and it quickly reaches the "Entry" position and stops blinking.
If it's raising to the normal road height, it will continue to blink "Raising". If I then hit the down button, it will quicky settle in to the road height and stop blinking.
I have not had that issue but there is a height sensor that tells the car when the selected height has been reached so perhaps the sensor is faulty or somehow tweaked.
I believe i am in the same boat. I have an issue with the air suspension constantly saying "raising" after I go from park mode to normal mode. It will not stop until I turn the vehicle off and back on again. Just from the Park position though. I need this TSB done and the one for the remote start. Gotta catch up.
I had the TSB done last week and it seems to of fixed the raising light from flashing but since then I have noticed that it dose not self level a few minutes after shut down any more. Can anyone else tell me if theirs still self levels?
Cheers.
After getting the tsb installed, I have only had the Quadra-lift continue to run after parking one time. I parked in a spot that was slopped down steeply. My previous, regular problems of overshoot are gone.
Tom
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Jeep Garage - Jeep Forum
1.7M posts
176.1K members
Since 2009
Jeep Garage is where you can talk about all your favorite jeeps including the Cherokee, Liberty and Grand Cherokee.