Jeep Garage  - Jeep Forum banner

My 2014 Deep Cherry Red Limited 4x4

6K views 10 replies 6 participants last post by  Sh0rtBus 
#1 ·
So I've had this thing since April 2013, but it still makes me smile every time I drive it. Well....at least until the radio starts acting up again.

Finally got a chance to take a few snaps with my DSLR with the RRO Leveling Kit and 20x9 ET18 XD Monsters and 265/60R20 Terra Grapplers thrown on. Just took it on a 1500 mile round trip drive to Missouri last weekend and it couldn't have been much better.

Pic was taken on the banks of the Mighty Mississippi in New Madrid, MO. Have more to process, but I've been lazy since I got back. Very long drive....

Please excuse the bugs....

 
See less See more
1
#3 ·
Thanks. Think I may have had my shutter speed a couple ticks to slow, though. Took a little more editing than I would've liked and the sky looks pretty blown out.
 
#9 ·
I don't at this point, no. My speedo is about 2mph slower than actual, though. Programmer is just not on the priority list for this Jeep. its' my daily and any mods usually go to the JKU first. Just installed Poison Spyder Crusher Corners and Crusher flares on my JKU a few weeks ago. And now I have a daughter on the way......:eek:
 
#10 ·
how are the MPG's with the wheels and tires? also any cutting or pinch weld bending needed to fit them with the RRO level?
 
#11 ·
MPG is about 17-18 on my mixed drive to work. Few lights, but not exactly stop & go traffic. And I'm not easy on the skinny pedal, either. I do usually keep it I ECO mode, though. Sacrilege, I know!

Didn't cut/bend any pinch seams at all, but I do get some contact on the outside corner of the front bumper on the driver's side when backing out to the right. Nothing major. Pulls the trim out some and I pop it back in. Need to replace the plastic rivet there.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top