Re: i-pad mounts
Originally Posted by ColdCase
No drilling anywhere. Remove the round plastic trim cover over the bolt that holds the seat rail to the floor (snaps out). Remove the bolt and then use it to fasten the RAM leg to the floor/rail. On the WK2 there is a bit of interference from the plastic seat rail trim, but I just tightened down the bolt solid without crushing the trim.
There will be a 1/2 in or so wobble when driving over sharp bumps, due to the spring in the long leg, but it is not distracting. Some have used Velcro or tie wrap between the upper part of the leg and something solid to reduce the sway.
You will also be missing the small trim piece.
ok. Great. That was very helpful
Follow GoldRatTooth @