Guys, for the moving lines to work. see below:
Connect LIN BUS CBC 3 (moving line signal) at Camera connector Pin 4 (circuit D403) to the InlineBody/IP 2 Connector Pin 27 (Orange/Dark Blue wire).
Other notes from my install below:
I purchased the pins here:
I made my own "harness" using this wire: (Use the bare wire as camera shield) and just add your own ground wire.
I used this site and followed every circuit for the "BACK-UP-CAMERA":
I used the factory ground location and the factory power circuit for the rearview camera.
Study each connector and circuit diagram and you will be able to get everything working including the moving lines just as I did. Just follow the circuit number to see where to terminate each wire.