Jeep Garage  - Jeep Forum banner

Check Engine Light

7K views 6 replies 4 participants last post by  radbushi 
#1 ·
I currently have the check engine light on and it's throwing 2 codes. P0730 which is a incorrect gear ratio and P0000. Any clue what could of caused this?
 
#2 ·
I cannot see signatures on my phone so I dont know if this info its there, but year, make, model, engine, trans?

Sent from my SCH-I500 using Tapatalk 2
 
#5 ·
this is a generic transmission code pretty much. I would take it in for an inspection at your SRT dealer. They can check the fluid, test drive etc. You can check the shifting yourself....shift from park to nuetral and then to reverse...back to nuetral and see what happens. DSame for drive. If you can check your tranny fluid....check for burnt fluid, bubbles and check on a white paper towel to look for particles. Then do a test drive. Come back...park on level ground and repeat the fluid check. I advise a dealer trip.
 
#7 ·
this is a generic transmission code pretty much. I would take it in for an inspection at your SRT dealer. They can check the fluid, test drive etc. You can check the shifting yourself....shift from park to nuetral and then to reverse...back to nuetral and see what happens. DSame for drive. If you can check your tranny fluid....check for burnt fluid, bubbles and check on a white paper towel to look for particles. Then do a test drive. Come back...park on level ground and repeat the fluid check. I advise a dealer trip.
No trany dip stick on these :)
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top