Re: X-Force Cat back now available @SolisMotorgroup
Well, it's on. Took a little longer than I was planning, but that was due to the fact that the old system weighs something like 100lbs and I wanted to take it off all in one piece so I could reinstall if needed someday.
I purchased new 1/2 stainless bolts/washers/nuts to connect the cat back system to the front flanges. The old spring loaded bolts could be used, but I was having an issue trying to tighten them w/o the bolts slipping.
VERY VERY happy with the sound. Kinda close to my 2015 392-Challenger. A little loud but not annoying. Even 4cy mode is very pleasant. Just a very mild amount of drone, a lot like the Challenger's factory exhaust.
The only improvement I would suggest is that the tips are a little low in the openings. Going to mess with it a little more tomorrow to see if I can make any fine tuning alignments, but not sure how since it hangs from the factory pins and rubber connectors.
Overall, it's an A in my book. I'll try to put up some pics tomorrow.