Jeep Garage  - Jeep Forum banner

DIY Pecca Leather Install

6K views 14 replies 10 participants last post by  jmckenna 
#1 ·
I got these off ebay from GuideMego. They are pecca leather seats. Overall I'm happy with the install. I think it looks a lot better then oem cloth. I took me about 20 hours to install with a steam machine. The hardest part was top of front seats. Headrests were not to bad.

Few things I do not like.
First GuideMego says the warranty policy is 3 years or 36,000 and advertises it as a DIY. But the warranty card that comes with the seats says its only covered if its installed by a Pecca Authorized Dealer and there is no authorized dealer stamp on the card.

The headrests were not to bad but the plastic mounting bands on the pecca front headrests were bigger then stock, so they did not clip in very well so I could not get a good tight fit.
 

Attachments

See less See more
3
#7 ·
20 hours!
 
#10 ·
Thanks all.

very snug fit, i had to use the stream machine to soften the leather to pull it over the seats. I paid 540 for the leather. I got mopar heated seats kit ( $320 ?) also since i would have the covers already off. I did a little each night after everyone went to bed, took me about 1 1/2 week.
 
#13 ·
Looks good but you have to redo the head rests


pull down the plastic cover on the back and snap in the strips on the leathe to the headrest frame you should get a little better fit.

I had the same problem when I did my Katzkin kit.

The headrest are the biggest pain in the but.
 
#14 ·
Nice job! Like others said, I definitely wouldn't have the patience for this.

I'd also like to see what the heated seat switch looks like when you get a chance.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top