Finally got around doing the gloss black SRT Taillamp bezel swamp on my 14' Altitude. I did not even realize how much better it makes the back look! Awesome. PLEASE DO NOT MIND THE DIRTY JEEP. It just rained earlier in the day and I had to get the bezels in since they were sitting on my doorstep from FedEx
Yeah those gloss black bezels are nice. I don't fully understand why Jeep decided on gray bezels on the altitude which doesn't really match anything. The Altitude has gloss black everything else, why in the heck didn't they just use the same gloss black bezels as the SRT? I don't get it.
I just ordered a set of the gloss black bezels for my Summit. Can't wait to get them along with my VLED V3 Triton LED's for my rear brake lights.
Looks awesome.
I would love to swap out the useless fugly chrome ones but all the black on my ride is FLAT. How and where would I find flat black ones ...
How do the inner-tails come off? I removed the 2x 10mm bolts and didn't want to pull too hard as they would not come out easily...I could remove the outters with no problem. Is there a trick to remove the inner tails? Any help is greatly appreciated
Quick question...to install the inner bezels did you remove the inner tail lights? I took the 10mm bolts off the inners and could not get them out. Do you have to remove the rear cargo panel lining? Or do the inner bezels just pop off...any help is appreciated
The bezels are attached to the light via a single screw and 3m tape. To remove the light there are four 10mm bolts to remove per light on the lift gate. You also have to disconnect several plugs. I recommend pulling the gate liner to gain full access.
I read that the original Chrome ones you can put some black vinil i dont Know if some one has done that and looks good? Or with some rain sun etc Will look bad.. Anyone try?
I read that the original Chrome ones you can put some black vinil i dont Know if some one has done that and looks good? Or with some rain sun etc Will look bad.. Anyone try?
The photo looks Nice, tell me does it look cheap? Like the 20 usd brembo calipers? You Know what i mean? Am considering doing it
Also what kind of vinil did you use?
Thanks!
The photo looks Nice, tell me does it look cheap? Like the 20 usd brembo calipers? You Know what i mean? Am considering doing it
Also what kind of vinil did you use?
Thanks!
Sent from my iPhone using JeepGarage[/QUOTE
Good question, can you tell is 3M vinyl for $10 or $150 srt bezel, is your money your choice, here are some more pictures of my $140 saving.
Good Luck!
You can find them on ebay from authorized mopar dealers but they are expensive. I purchased them but you can also try your hand as vinyl wrapping them as that would be a cheaper route.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Jeep Garage - Jeep Forum
1.7M posts
176.1K members
Since 2009
Jeep Garage is where you can talk about all your favorite jeeps including the Cherokee, Liberty and Grand Cherokee.