Jeep Garage  - Jeep Forum banner

SPOD WK2 Install

Tags
wk2
6K views 5 replies 3 participants last post by  esierens 
#1 ·
The SPOD is installed on top the fusebox cover of a 2014 JGC Overland with a 5.7 HEMI. The hood strut is directly above the install location but it does clear by .25”. I am installing the SPOD SE system with touchscreen and the universal bracket. You must use the SE version if you want to install in this location due to the fact that this model is shorter by .50”. This model uses MOSFET circuitry and has no fuses per switch channel.

Since the battery is located under the passenger seat, I used the Jump terminals under the hood for power. The end if the terminals just screw off of a stud where you can attach your electrical leads. I will run the single cable through the firewall from the SPOD source to the monitor tomorrow, and update this post with pictures.




http://www.jeepgarage.org/attachment.php?attachmentid=59955&stc=1&d=1440892904
 

Attachments

See less See more
10
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top