Jeep Garage  - Jeep Forum banner

Turn signal in side mirrors

29K views 45 replies 14 participants last post by  h2dro 
#1 ·
Ok, so my 2011 Laredo X does not have it, but I WANT IT! If I go and order a set of Limited side mirrors, with the turn signals built in, is the harness available in my Laredo door you think? Any ideas are welcome!
 
#6 ·
I would bet that all is needed is the signal mirror. At the most...you may have to tp into the turn signal wire at the front headlight signal
 
#7 ·
If your able to follow the wire harness up to the mirror, check to see if there is more spots then wires in the connector or wires that aren't being used?
 
#15 ·
So were you able to figure out how to install these? I also have a Laredo and would like the blinkers. I don't really want to buy a whole new mirror housing, but maybe just the bottom portion that has the blinker part to it. Will all the wiring be there? or will I need to run extra wires?

Also, anyone know of a way to install power folding mirrors after the fact?
 
#20 ·
your gonna laugh...but I paid $45 for the mirror shipped on ebay....

if it works...Ill buy a passenger side and have them painted to match
 
#23 ·
you can replace the chrome casing with your painted casing very easy. Tilt the mirror all the way to the inside and then pull gently on the glass and it pops off. Fold the mirror in and remove the one screw on the outside. Fold back out and release the four tabs holding the chrome casing on....then just push your painted casing back in making sure the tabs lock. then add screw and mirror glass back on. Easy 10 minute job. The mirror doesnt even have to be removed.
 
#25 ·
they are all folding bro. Do you mean power folding? There are none in the US. Theres a few mirrors on ebay and car-part.com
 
#26 ·
Yes I meant power folding and yes I know they are not US standard... give it a few years and I am sure it will be. I'd be interested to see if the non-US power-folding mirrors actually work on the US models. You would need to punch through the plastic and add the button, but that is an easy fix.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top