Jeep Garage  - Jeep Forum banner

Whited out raised graphics in engine compartment

3K views 13 replies 8 participants last post by  Jeep_addicted 
#1 · (Edited)
Today was my first, and probably last day for a while, to fully obsess over my Durango all day long. I double checked every painted surface and fastener connections for flaws, found none other than I already posted. I decided the flog lights where way off color temp from the HID lights so I put in SilverStar Ultras (4,100K). I know the filaments burn hotter and don't last long but I rarely drive at night. I didn't notice that much difference, during the day anyway, so I'll double check at night. Itching to do something more, I whited out the raised lettering and graphics on the plastic in the engine compartment for the battery terminals, fuse box and power steering.
 

Attachments

See less See more
2
#4 ·
What did you use?
 
#11 ·
Thanks for the tip! Here are my results below:

Vehicle Car Engine Auto part Technology


Vehicle Car Bumper Automotive exterior Hood
 
#12 ·
#14 ·
Glad to see there are others out there detailing their engine bays.

I had some 'one shot sign painters paint" in flat red and I used it highlight the graphics that show the jump start posts.

Now I will have to go back and to all the other little raised graphics. Off to the stationary store to buy a can of gloss white "ONE SHOT".....
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top