Jeep Garage  - Jeep Forum banner

Check Engine Light Codes

4K views 5 replies 3 participants last post by  jakeferneau 
#1 · (Edited)
:mad: :mad: :mad:

Alright, I need help.
I recently got a 2005 Grand Cherokee 5.7L with 130k miles and the check engine light came on. I took it to a shop to have it read and these are the codes its throwing.
C107C
U0114
U140E
U0126
P2098
U1411
P0153

It runs and drives perfect. There is no weird noises. Doesn't show any problems when driving. Everything on the car works just fine.
Does anybody have any suggestions? I've had the codes erased and the light comes back on after driving about 50-70 miles.
Does anybody know what could be causing this or if there is something that i should replace?
 
#3 ·
Well it wasnt really a shop. Just a car lot that I stopped at and the guy there had a OBD-II scanner and he told me the codes. He really didn't know since the car doesn't have any symptoms of anything. He thinks it could be one thing wrong making a few codes pop up instead of just one code.
 
#4 ·
Can you get them cleared and then see what codes get set? some of those might be old codes, which will confuse the diagnosis..

the best I can do decoding them is:
C107C - not in my FSM, but probably a brake-pedal sensor code
U0114 - LOST COMMUNICATION WITH FINAL DRIVE MODULE
U140E - IMPLAUSIBLE VEHICLE CONFIGURATION DATA RECEIVED
U0126 - LOST COMMUNICATION WITH STEERING ANGLE SENSOR
P2098 - DOWNSTREAM FUEL TRIM SYSTEM 2 LEAN
U1411 - IMPLAUSIBLE FUEL VOLUME SIGNAL RECEIVED
P0153 - O2 SENSOR 2/1 SLOW RESPONSE
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top