Jeep Garage  - Jeep Forum banner

Low voltage to blower fan switch on a compass

1K views 0 replies 1 participant last post by  Dmiles1 
#1 ·
My blower fan stopped working and I have replaced the resister with no luck. I pulled off the bezel and disconnected the wire harness from the switch to check the voltage to the switch . The meter is only reading just over 6 volts. I suspect this should be 12 volts coming to the switch.

Thinking it might be the ground, but I have no idea where to trace this back without tearing the dash apart.

Any help would be appreciated ?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top