Jeep Garage  - Jeep Forum banner

Problems with low beam hids

3K views 6 replies 5 participants last post by  DanD2124 
#1 ·
I purchased 2 sets of HID kits from V-LEDs.com . 6000k Low Beam and 6000k Fog Lights. I decided to install the HIDs today and ran into a problem. When i connected the ballasts (low beam) the ballast and the red wire started making a buzzing sound (the lights were in the OFF position) I connected the bulbs and they started flickering like a strobe light with the lights being off, I turned on the low beams and it seemed to work fine, as soon as i turned them off, they started flickering again for about 30 seconds and then turn off. I thought its the ballast, but I tried 4 ballast, but i had the same problem with BOTH Low Beams. Fog Lights seemed to work just fine. I am trying to figure out what the problem could be. Anyone experienced this before and know a solution to it? Or should i just return the HID kits and try out a different set?
 
#3 ·
yep, relay will do it!
 
#5 ·
You can get them anywhere really, but there is a good vendor on this forum (xenon depot).
 
#7 ·
3X to that.
They have been very good to deal with. Make sure you get a relay each light. Especially the low beams. I've heard of people getting away with out them for the fogs but better safe than sorry.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top