Jeep Garage  - Jeep Forum banner

Replacing Hood Release Handle & access??!!

11K views 1 reply 2 participants last post by  brentwoodkris 
#1 ·
I went to 'pop' the hood on my WK and the metal cable and hood release handle separated. After looking at the backside of the release handle I can see that it broke, where it holds the cable in place.

My question is, what is the best way to replace this handle? I already purchased a cable and handle release kit, but only am planning on using the handle only (the cable is fine)

How do I remove the trim piece or kick panel?

Any tips/advice is really appreciated! Thanks!
 
#2 ·
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top