Jeep Garage  - Jeep Forum banner

h1 retrofit headlights to 2007 SRT8 w/ factory 9006 lows

3K views 2 replies 3 participants last post by  BostonstrongHemi 
#1 · (Edited)
h1 retrofit projectors to 2007 SRT8

Having a retro fit done to the headlights. The projectors are for h1 bulb/base so i ordered the H1 Xtreme Digital HID Conversion Kit from kbcarstuff. Was this the right route to go to make it work or should of have got the 9006 HID kit?


Also their relay harness is currently on back order so they ended up shipping the HID kit without the relay harness. Since there is no ETA on when they will get the relay harness i may go purchase one so i can put it in. Do i need to get a specific H1 or 9006 harness and do you have any recommendations on where to get one. Also would i need canbus or no?
Below is the relay harness that kbcarstuff which are on back order.

Headlight Wiring Harness for an HID Kit


Mopar HID Wire Harness Kit


Thanks.
 
#2 ·
any hid harness will do.. One tip, you have to ground the harness. I chose the small 10mm bolt on the fender in front of the coolant resevoir. It is a great place to ground...lights are grounded there. Anyway, Dont forget to tighten this back down or you'll be wondering why you courtesy lamps are only working on one side. LOL the blinker will work, very dim and hazards will work too.....courtesy won't light up.
 
#3 ·
Re: h1 retrofit projectors to 2007 SRT8

Spend the money on a good relay/wiring harness, it's worth having the piece of mind knowing it won't fail in a few years of being in an engine compartment. Try to use factory grounds too. The HID conversion was one of the better upgrades I've done to my wk, good luck!


Sent from my iPhone using JeepGarage
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top