Re: Bumper Install
very easy......do you have a plastic rivet setter, rivets and all screws/bolts/fastners? Do you have the 06-07 or 08-10 bumper?
1-remove grille and old bumper-cut rivets or drill them out to remove them from the fender well
2-if you have the 06-07 SRT bumper-add the triangular SRT fender liner extentions. they are labeled left and right. Use rivets setter and rivets to attach. skip this step if you have the 08-10 bumper
3-attach the two lower bumper support arms-use one bolt from the skid plate to attach eah arms. They are labeled L/R as well.
4-attach the SRT brake ducts with the supplied push pins to the upper frame rail.(skip if you dont have these)
5-lay the SRT bumper on a soft surface face down(on bed sheets, blanket etc)
6-attach foglamps(two screws each) and lower grill-presses into place
7-attach SRT lower plastic support bracket to the bottom of the SRT bumper with supplied push pins
8-attach the two supplied metal clips where the support arms attach to the lower lip of the bumper(second slot from the end on the lower bumper lip)
9-with help.....set bumper into place and align the attachment holes on the top of the bumper with the holes on the upper bumper support. Push in push pins.(08 bumpers snap INTO the support bracket)
10-line up lower support arms into their space and add the bolt from the bottom up through the metal clips
11-align each fender liner and add plastic rivets
12-lay down under bumper and use the push pins to attach the lower plastic support to the upper frame rail of the Grand Cherokee. Plug in fog lamps
13-use push pins to attach the brake ducts to the bumper
The HARDER you work...the LUCKIER you are!
2014 REDLINE red Jeep SRT "BLOODIED\BlackOps CFR Edition" 1 of 1
2013 JKU Wrangler 10A
, JW Speaker and more!
Previous JEEP rides-
2013 Jeep Grand Cherokee SRT-deep cherry
2006 Jeep Grand Cherokee Laredo-inferno red