Jeep Garage  - Jeep Forum banner

Let there be light!!!!

2K views 6 replies 2 participants last post by  zero_psi 
#1 ·
so i have 2 130 watt day lighters and 2 55 watt hid swapped hella 500ffs on my rolla roof basket and i was wondering what is the best way to wire thease in. i dont want to cut or do anything janky. i was also wondering what gauge wire to use... i have wired lights before but they were on a brush gaurd so i was not worried about cutting or where to run the wire for a clean install

any help would be great!!:thumbsup:
 
#2 ·
You probably want to use 14 awg cable to wire this. You deffinatley want to use 2 relays as well for each set of lights. You can crimp on a set of 9006 connectors to make it a cleaner connection into the ballst. For switches check out my new switches post that I just installed.
 
#4 ·
You can run the wires to above the driver side door then put it behind the gasket and run it all the way down to inside the engine bay. Connect to relay and grounds. They use the hood release grommit to run the positive trigger wire into the jeep. Then you can use any switch really.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top