Hey guys, I posted a few months ago after struggling to replace my rear reverse LED light. The prior owner had to replace one of the rear tail lights. Right now I was able to install LEDs into the harness that has 3 separate houses, each that you squeeze to pull out.
I'm having trouble fitting it into the other socket, which is depicted below. As you can see, the bulb is basically hanging half out.
My question is then, assuming my 2006 jeep has one 2006 housing and a 2008+ one as well I need to figure out which housing is the one that I can't fit into and then the corresponding bulb size I need to properly fit. Right now I'm rocking one LED and one Halo...kinda lame haha