Jeep Garage  - Jeep Forum banner

AFE CAI and Catch Can

4K views 7 replies 7 participants last post by  Rob07WK 
#1 · (Edited)
Installed AFE CAI and catch can yesterday. I like the was the AFE uses the factory lower air box






 
See less See more
6
#4 ·
Nice set up got the same for my Hemi , I wish I put the catch can on day one, the Hemi intake suck lots of oil.
 
#5 ·
I like the AFE design as well, but took it off and went back to stock, as my better half drives the WK now and likes the quiet stock intake. I have the AFE II for sale, 1/2 price in the FS section, with new rubber coupler and cleaning /oil kit.
 
#7 ·
Just remove the "cup" from the bottom of the airbox, install an aluminum tube on it and route it out to behind the grill. Also, punch a small hole at the bottom (lowest point) of the new tube so it will drain any water that gets in. This was one of the first mods. I did when I got my WK. It'll flow as good as any aftermarket CAI and will give you all cold air too. I later installed a modified LX SRT8 airbox which, IMO is better yet.
 

Attachments

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top