Re: Cleaning throttle body
I'm sure there's a how to on here somewhere. But basically all you need to do is disconnect the battery, remove your air intake/air dam, and then disconnect the electrical connector on the top of the TB, and remove the 4x8mm screws holding on the TB to the intake manifold (ideally by slightly loosening each first as to not warp the aluminum). Then go crazy with a toothbrush and a can of carb cleaner but be careful not to get the plastic housing wet (as it's an expensive piece to replace). Just did this to both my HEMI's a couple weekends ago.
When you see all the carbon build up, you'll realize why you'll want to invest in a catch can.
'05 WK GC 5.7L HEMI, Goodyear Wrangler SilentArmors, Monroe Reflex Front Struts/Monroe Load Adjusting Rear Shocks, EBC Drilled/Slotted Sport Rotors, Wagner Ceramic Brake Pads, Taylor Shorties, SRT8 Stock CAI Conversion, K&N Drop-in, Block Heater, 18.5% Tint All Around, Boston SE Speakers, 12" Alpine Type-R Sub w/ sealed box w/ RF PRIME R1000-1D, ScanGauge II w/ windshield mount, BT Catch Can w/custom bracket, Swagman Fork Mount Bicycle Rack, WeatherTech front floor liners, SRT8 Pedal Covers, eBay full LED lighting kit, Custom MDS Indicator LED Light, Mega Raizin Voltage Stabilizer & Grounding Kit, Challenger IAT Sensor, Escort Passport 9500ix, Python 5706P RS/Security/KE w/ extras, SA 5 switch panel, Fumoto Oil Valve, Overland WG Steering wheel.