Re: Laredo Seat Swap Help
Anyone else have any suggestions? Or maybe know where I could get a wiring diagram of the Laredo ?
I have all the plugs for the seats and even the switch panel for the dash was included. However the wires were just chopped under the seat so I don't got the whole harness, just plugs with enough to splice.
Does anyone know if I were to find where run the wires, would my computer recognize it since I only have a Laredo trim level? I know with some auto manufacturers it isn't too complicated to swap heated power seats into models without them but it appears this may not be the case with the Jeep.
I don't really want to pull power from driver side seat but assuming I did, would I have to upgrade my fuse? Is this my only option? I'm not opposed to running a new set of wires to accommodate the passenger power seat assuming its only that missing from the equation but some make it sound like that is out of the question.
It seems like it would be something rather simple to go from manual passenger to power passenger but who knows maybe Jeep really is that driven on getting you to buy a higher trim level. Really wishing I would have now if that is the case, I always assumed I could swap parts from other trim levels. Well interior parts anyway.
My plans had been to go the Katskinz route as well but thought I had a good shot at getting leather with heated seats and power for less than the Katskinz kit alone. I'm not given up yet though I just need someone who knows the electrical of the Jeep inside and out to chime in. Anyone know who that might be on this forum?
Thanks again for the help. It's greatly appreciated. I don't want these seats to be a wasted purchase.