Jeep Garage  - Jeep Forum banner

Off Road Lights

13K views 46 replies 16 participants last post by  Band1t 
#1 ·
I want to install a set of off road lights without having to buy a bull bar or brush gaurd or rack. Is there any way of doing this by mounting them on the car somehow. I would love some ideas. Thank you.
 
#11 ·
Yea they're wired to their own switch. I mounted it in the small cubby underneath the temp control. If you don't know its there you would never be able to tell.

can you take a night pic? does the grill get in the way?
The grille cuts back on some of the output, but I knew that before I mounted them. Here's a few pics.

Lows, Fogs and Hellas above all the cutoffs lines.


Lows, Fogs, and Hellas in the Hellas beam.


Highs and Hellas in the beam again.
 
#17 ·
Thanks, I actually stumbled upon their stuff last night after posting that.

I wanted a set of stillens, and was going to have them painted to match the color of my Jeep. But I didn't want to drop 120$ on the stillens and another 100$ to have them painted. So I had some plasti dip left over from my wheels, and I used that to make my own. I used blue painters tape to tape the lines, and covered up the areas around it, and then painted it with plasti dip. I wasn't sure how it would come out but I love the look of it. It kind of goes along with the rest of the black accents on the Jeep.



Sent from my DROID4 using Tapatalk 2
Awesome, I wondered how feasible that would be. Did you sand or anything prior to paint? It looks awesome. I love that color WK. A rare breed here in NC. Only seen one or two, maybe.

Nice vehicle.
 
#16 ·
I wanted a set of stillens, and was going to have them painted to match the color of my Jeep. But I didn't want to drop 120$ on the stillens and another 100$ to have them painted. So I had some plasti dip left over from my wheels, and I used that to make my own. I used blue painters tape to tape the lines, and covered up the areas around it, and then painted it with plasti dip. I wasn't sure how it would come out but I love the look of it. It kind of goes along with the rest of the black accents on the Jeep.



Sent from my DROID4 using Tapatalk 2
 
#18 ·
Thanks man. I've only seen one other this color up here in my hometown. It was super easy, and a lot cheaper than buying Stillens. The only prep I did was to clean the area I wanted to spray, then I taped it off and sprayed away. Its held up great and if I ever get sick of it, I can just peel it off.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top