Re: Changing valve seals
Not a difficult thing to do at all Aaron. If the tranny pan is of already and the inlet filter is removed, you only need to disconnect the big connector on the LH side of the tranny and remove 6 bolts which holds the valve body housing to the tranny. When i´m not wrong the TRS/Solenoid assy is hold to the valve body by 15 TorqX -25 screws. When installing the TRS/Solenoid assy to the valve body, fasten first the 2 screws marked with a pointer (on the valve body) and then the rest. Not sure about the reason for that, but its mentioned in the manual. I also received a new selector plate, but couldn´t discover any differences between the old and the new one. Since i had the new one, i used it.
I think it takes you one hour to remove the valve body, change the TRS/Solenoid assy and put it back in place. From start to finish (removing tranny pan until filling it up again) it takes maximum 3 hrs.