Jeep Garage  - Jeep Forum banner

Re-useable Splash Shield clips.

3K views 7 replies 4 participants last post by  JETLIFE 
#1 ·
Since I replaced the splash shield which got ripped by the tire when I forgot to tuck the front part back when I installed the bracket of the HID ballast under the fender, I did not buy the clips thinking that I might open it up again incase the ballast goes bad and break those damn clips again and waste money. I instead replaced it with these.




This is how it looked without the clips....

Just slide it and make sure it lines up with the bumper holes and lock it up.



Now I have a reusable one! Yay!

Only thing I would like to change is, if I can find a flatter head so it would sit flush with the bumper. But thats for another day....
 
See less See more
7
#7 ·
I saw a lot of those with different sizes, but when I was toying with it, it seems that they didn't spread wide enough to cover the gap on the holes of the splash shield.... Hmmm, maybe I need to bring a couple home for a test fit....
 
#8 ·
I did the same thing as OP, much better than plastic clips.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top