Go Back   Jeep Garage - Jeep Forum > Jeep Platform Discussion > Grand Cherokee - WJ > Troubleshooting/Problems

Join Jeep Garage Today
Reply
 
Thread Tools Display Modes
 
  #1  
Old 04-30-2011, 09:00 PM
New Member
 
Join Date: Apr 2011
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
jeep_doral is on a distinguished road
A/C low pressure passenger side with new blend doors

Hi,

I replaced my blend doors today after having almost no air blowing from the passenger side. Just as expected, the right door was broken. Replaced with new doors, checked everything was working as it should, assembled and only to find that the passenger side A/C is still not blowing as the driver side, about 80% less.

Can the vents be blocked by something? I'm I missing a filter somewhere?

Suggestions greatly appreciated.

1999 Jeep GC Limited
__________________

__________________
Reply With Quote
  #2  
Old 04-30-2011, 09:29 PM
Frango100's Avatar
Premium Member

My Jeep: 2004 4.7L WJ
 
Join Date: Dec 2009
Location: Brazil
Posts: 5,157
Thanks: 9
Thanked 116 Times in 109 Posts
Rep Power: 526171
Frango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond repute
Re: A/C low pressure passenger side with new blend doors

When you had the system open, did you check the ducts as far as possible for any restrictions or debris? Are the air outlets completely open on the passengers side? If you close the outlets on the drivers side, do you have a lot of air on the passengers side? Makes it any difference selecting high or low temperature?
Regarding the blend doors, they only redirect the air over the heater core or not. If temperature selection would make a big difference in air flow, then there should be some restriction in the heater core.
__________________

__________________
Frank

JEEP Grand Cherokee 4.7 Lmtd 2004
HID 8000K in low and fog / Quad Squad member
KYB Gas-a-Just shocks / Pirelli Scorpion ATR 245/65/17 - Transgo reprogramming shiftkit.

VW Beetle 2.0 TSI 2013
My new toy
Reply With Quote
  #3  
Old 04-30-2011, 10:33 PM
New Member
 
Join Date: Apr 2011
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
jeep_doral is on a distinguished road
Re: A/C low pressure passenger side with new blend doors

Hi Frank,

Closing the driver side outlets makes no difference in pressure. The center outlets right below the radio, left side has full air, right side almost no air blowing. I just can't figure a vent door or something that can make air vent to one side and not the other.
__________________
Reply With Quote
  #4  
Old 04-30-2011, 10:34 PM
New Member
 
Join Date: Apr 2011
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
jeep_doral is on a distinguished road
Re: A/C low pressure passenger side with new blend doors

Forgot to add, temperature has no impact on the air output from the outlets, heat or cold, same volume of air.
__________________
Reply With Quote
  #5  
Old 05-01-2011, 07:50 AM
Frango100's Avatar
Premium Member

My Jeep: 2004 4.7L WJ
 
Join Date: Dec 2009
Location: Brazil
Posts: 5,157
Thanks: 9
Thanked 116 Times in 109 Posts
Rep Power: 526171
Frango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond repute
Re: A/C low pressure passenger side with new blend doors

When you close the vents on the drivers side, does the fan make a different sound, as if the air canīt go anywhere? If it doesnīt change, then there must be air escaping somewhere. Did you feel for airleaks in the passenger footwell area. If the airflow on the pax side doesnīt increase when closing the drivers side outlets, then there must be any kind of restriction in the pax side ducts.
Iīve heard problems before of uneven airflow and i think they are never exactly the same, but 80/20 is quite a difference. The only doors different for drivers side and pax side are the blend doors. Did you calibrate the doors to be sure that they go full open and full close? The other doors in the system are the mode door and the recirculation door, but they are common for drivers side and pax side.
__________________
Frank

JEEP Grand Cherokee 4.7 Lmtd 2004
HID 8000K in low and fog / Quad Squad member
KYB Gas-a-Just shocks / Pirelli Scorpion ATR 245/65/17 - Transgo reprogramming shiftkit.

VW Beetle 2.0 TSI 2013
My new toy
Reply With Quote
  #6  
Old 05-01-2011, 11:07 AM
Member
My Jeep: 2004 4.7 HO WJ
 
Join Date: Jan 2011
Location: Fortville, Indiana
Posts: 109
Thanks: 1
Thanked 0 Times in 0 Posts
Rep Power: 1501
Me Fix is on a distinguished road
Re: A/C low pressure passenger side with new blend doors

What fix did you do? Did you cut the box open from the front and install both doors tied together or did you do the Pro fix and take the dash and duct out so that you could install both doors seperate.

I bought my 2004 Overland used and I have error codes 52 and 56 although per Frank I was able to clear code 56, but still have 52. I may be in for fixing my doors soon. I'd rather fix them at my convenence rather than being on a trip and having problems then. I have read where some have the "cabin filter" which filters the incoming air. That would not effect the one side though, but if you have it and didn't know it, it could actually come apart and become part of a blockage that would effect one side or the other.
__________________
Reply With Quote
  #7  
Old 05-01-2011, 03:26 PM
New Member
 
Join Date: Apr 2011
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
jeep_doral is on a distinguished road
Re: A/C low pressure passenger side with new blend doors

I did the "easy" and economical fix. Bought the blend doors and installed them myself by cutting the box. Not going to pay $$$ to have this fixed, it only cost me $100+ and the pleassure of doing it myself.

I did install the cabin filter a few months ago, I added it, was not part of the car. I can't see where it would block half side of the vents, but will give it a try.

I haven't tested any changes on the defrost or other air outputs, will try that as well. Some research I did this morning on the web calls mentions that the vacuum might be not working properly, it's an inexpensive part so I guess I'll just exchange it to clear that.

Will update any results after removing the cabin filter.

Thank you for all your comments.
__________________
Reply With Quote
  #8  
Old 05-01-2011, 06:07 PM
Frango100's Avatar
Premium Member

My Jeep: 2004 4.7L WJ
 
Join Date: Dec 2009
Location: Brazil
Posts: 5,157
Thanks: 9
Thanked 116 Times in 109 Posts
Rep Power: 526171
Frango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond repute
Re: A/C low pressure passenger side with new blend doors

With the AZC airco system, no vacuum actuators are used, it only has electrical actuators. So what should be the problem with vacuum?
__________________
Frank

JEEP Grand Cherokee 4.7 Lmtd 2004
HID 8000K in low and fog / Quad Squad member
KYB Gas-a-Just shocks / Pirelli Scorpion ATR 245/65/17 - Transgo reprogramming shiftkit.

VW Beetle 2.0 TSI 2013
My new toy
Reply With Quote
  #9  
Old 05-02-2011, 08:17 AM
New Member
 
Join Date: May 2011
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
Blen Dor is on a distinguished road
Re: A/C low pressure passenger side with new blend doors

Hello Jeep Doral:

The first thing you should do to diagnose the HVAC system is to read the fault codes.

That would be a good place to start your heater diagnostics.

To read the fault codes:
1. Turn on the ignition switch.
2. Turn on the AZC system. The temperature settings should be displayed for both sides.
3. Simultaneously hold down the AC and the Re-Circ buttons.
4. Then turn the driver’s side temperature (Left) control knob to the right (CW) one click.
5. Then release the AC and Re-Circ buttons.

If there are no fault codes, the “00” display value will remain in the window.
If there are any codes, each will be displayed for one second in ascending numerical sequence (note: no effort is made to display faults in the order they occurred). The left side set temperature display will be blanked and the right side set temperature display will indicate current and historical codes (8 historical max) presently active.
Once all codes have been displayed, the system will repeat the fault code numbers. This will continue until the left side set temperature control is moved at least one detent position in either direction, by pressing both the A/C and Recirc buttons at the same time, or the ignition is turned off.

Maybe the fault codes will direct you to the problem.

Post your fault codes, if you need help interpreting the code numbers.
__________________

__________________
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Low oil pressure and engine light flashing violant00 Engine Performance/Intake/Exhaust 17 11-14-2011 11:29 AM
Hot or Cold - Blend doors? or Resistor? JETLIFE Grand Cherokee - WK 3 03-28-2011 02:02 PM
Blend doors and intermitent heat FredoinSF Troubleshooting/Problems 15 01-11-2011 10:31 AM
Low Spare Pressure Solution 555ctsv Grand Cherokee - WK 3 02-21-2010 04:12 PM
Blend Doors jon022191 Troubleshooting/Problems 2 12-28-2009 11:16 PM

Powered by vBadvanced CMPS v3.2.3

All times are GMT -5. The time now is 01:10 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community

JeepGarage.org is in no way associated with or endorsed by Chrysler Group LLC.