Jeep Garage  - Jeep Forum banner

blinker

2K views 5 replies 3 participants last post by  kennzz05 
#1 ·
hi guys &gals have a wj with a very lazy lh blinker.have replaced flasher stork and flasher can.any hints:confused:
 
#2 ·
What do you mean with flasher stork? and flasher can????
I presume that one of the 2 the combination flasher relay is?
Normally when 1 bulb burns out, the flasher starts blinking faster. So when it flashes slower, i would think that a wrong type bulb is installed, which uses too much current. Is any of the bulbs brighter then normal? Did you change a lightbulb lately?
 
#5 ·
Don't think so. The combination flasher contains active electronic Integrated Circuitry (IC) elements, no warp switch to let it flash.
One bulb burnt increases the flash intensity (but lowers the current), so my thinking is then that with a lower flash intensity, the current should be too high.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top