Go Back   Jeep Garage - Jeep Forum > Jeep Platform Discussion > Grand Cherokee - WJ > Troubleshooting/Problems

Join Jeep Garage Today
Reply
 
Thread Tools Display Modes
 
  #13  
Old 12-07-2011, 08:14 PM
Frango100's Avatar
The BEAST from Brazil

My Jeep: 2004 4.7L WJ
 
Join Date: Dec 2009
Location: Brazil
Posts: 4,338
Thanks: 8
Thanked 32 Times in 31 Posts
Rep Power: 524738
Frango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond repute
Re: Transmission fluid

ADJUSTMENT - BANDS
FRONT BAND
The front (kickdown) band adjusting screw is
located on the left side of the transmission case
above the manual valve and throttle valve levers.
(1) Raise vehicle.
(2) Loosen band adjusting screw locknut (Fig. 68).
Then back locknut off 3-5 turns. Be sure adjusting
screw turns freely in case. Apply lubricant to screw
threads if necessary.
(3) Tighten band adjusting screw to 8 Nm (72 in.
lbs.) torque with Inch Pound Torque Wrench
C-3380-A, a 3-in. extension and appropriate Torx
socket.
CAUTION: If Adapter C-3705 is needed to reach the
adjusting screw, tighten the screw to only 5 Nm
(47-50 in. lbs.) torque.
(4) Back off front band adjusting screw 3 turns.
(5) Hold adjuster screw in position and tighten
locknut to 41 Nm (30 ft. lbs.) torque.
(6) Lower vehicle.


REAR BAND
The transmission oil pan must be removed for
access to the rear band adjusting screw.
(1) Raise vehicle.
(2) Remove transmission oil pan and drain fluid.
(3) Loosen band adjusting screw locknut 5-6 turns
(Fig. 69). Be sure adjusting screw turns freely in lever.
(4) Tighten adjusting screw to 8 Nm (72 in. lbs.)
torque.
(5) Back off adjusting screw 4 turns.
(6) Hold adjusting screw in place and tighten locknut
to 34 Nm (25 ft. lbs.) torque.
(7) Position new gasket on oil pan and install pan
on transmission. Tighten pan bolts to 17 Nm (13 ft.
lbs.) torque.
(8) Lower vehicle and refill transmission with

Mopar
t ATF +4, Automatic Transmission fluid.

Attached 2 pictures i took from the manual with the locations of the adjusting screws.
Attached Images
File Type: jpg 07122011840.jpg (177.7 KB, 8 views)
File Type: jpg 07122011841.jpg (171.6 KB, 6 views)
__________________

__________________
Frank

JEEP Grand Cherokee 4.7 Lmtd 2004
HID 8000K in low and fog / Quad Squad member
Monroe Reflex shocks / Pirelli Scorpion ATR 245/65/17 - Transgo reprogramming shiftkit.

VW Beetle 2.0 TSI 2013
My new toy
Reply With Quote
The Following User Says Thank You to Frango100 For This Useful Post:
  #14  
Old 12-09-2011, 12:27 PM
Member
My Jeep: 2004 4.0L WJ
 
Join Date: Oct 2011
Location: Iceland
Posts: 20
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 930
Jinx is on a distinguished road
Re: Transmission fluid

Thanks a lot for these info I hope Ill be able to do this in the weekend I'll be in touch if I screw it up.


:-)
__________________

__________________
Reply With Quote
  #15  
Old 12-11-2011, 11:16 AM
Member
My Jeep: 2004 4.0L WJ
 
Join Date: Oct 2011
Location: Iceland
Posts: 20
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 930
Jinx is on a distinguished road
Re: Transmission fluid

Everything went as planned, I changed the tranny fluid and filter adjusted the bands and changed the differentials oil.
I think I got Dana 44 rear because it took over 2 liters of oil, is that possible with the I6 engine?
Are there any ways to tell by looking under the car?
Thanks for all the advise.

Jinx
__________________
Reply With Quote
  #16  
Old 12-11-2011, 03:28 PM
Frango100's Avatar
The BEAST from Brazil

My Jeep: 2004 4.7L WJ
 
Join Date: Dec 2009
Location: Brazil
Posts: 4,338
Thanks: 8
Thanked 32 Times in 31 Posts
Rep Power: 524738
Frango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond reputeFrango100 has a reputation beyond repute
Re: Transmission fluid

I forgot which year your Jeep is, but it could have the Dana 44 with the I6.
When i'm not wrong, the type should be stamped somewhere on the diff housing.
But if it took more then 2 Lts, you should have the Dana 44.
__________________

__________________
Frank

JEEP Grand Cherokee 4.7 Lmtd 2004
HID 8000K in low and fog / Quad Squad member
Monroe Reflex shocks / Pirelli Scorpion ATR 245/65/17 - Transgo reprogramming shiftkit.

VW Beetle 2.0 TSI 2013
My new toy
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Replacing my Transmission fluid soon Amelie Troubleshooting/Problems 5 10-19-2011 10:29 PM
Adding Transmission Fluid 06HemiLtd Grand Cherokee - WK 12 08-27-2011 11:55 PM
Transmission Fluid in Radiator? 555ctsv Grand Cherokee - WK 7 12-15-2010 07:48 PM
Transmission fluid Frango100 Troubleshooting/Problems 5 07-08-2010 12:33 PM
Transmission fluid adesisto Troubleshooting/Problems 8 01-28-2010 06:41 PM

Powered by vBadvanced CMPS v3.2.3

All times are GMT -5. The time now is 03:36 PM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
Copyright 2012 - JeepGarage.Org
The Jeep Grand Cherokee Owners Community