Jeep Garage  - Jeep Forum banner

transmission problem

3K views 4 replies 4 participants last post by  mon_21 
#1 ·
Hi my 2001 3.1 ltr diesel will not change from first gear until approx 4000 rpm.After that changes appear normal but once you slow down the problem reoccurs on acceleration. Did code check and got P1762. Anyone shed light on this prob?
 
#2 ·
P1762 Governor Pressure Sensor Offset Improper Voltage.
Have no experience with it, but i think that you have to change the governor pressure sensor.
 
#4 · (Edited)
Don't know which tranny you have on your Jeep, but the sensor will probably look as here attached. After some surfing on the net i also found several recommendations to change the governor solenoid at the same time, to prevent opening of the tranny soon again. No idea how much this solenoid will cost and if it will be costs effective to change it now.
Also the problem could be caused by an open or shorted wire to the governor pressure sensor. So its a good idea to check the wiring before changing any part.
 

Attachments

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top