Re: DEF INJECTOR and Harness protection group buy
@ dom42- I was thinking about the toggle bolt used in the rear factory slotted hole and I was worried that the toggle might fall into the frame and rattle around if the plate is removed to replace the injector.
I wonder if it would be possible to use a 3/8-16 "Nutsert" with the appropriate stainless fender or regular washers clamped on the inside and outside of the frame by the Nutsert when it is compressed during installation. The washers would have to be clamped in place to stop them turning to allow the Nutsert to expand. The Nutsert would become a permanent threaded hole in the frame and allow removal and reinstallation of the plate.
The Nutserts are available in 1/2, 3/8 , 5/16, and1/4" bolt sizes and in various materials for different grip lengths. I think that Jeep used some 1/2" ones in the past for mounting skid plates. Just another possible solution per your first post.
Purchased 12Nov13: '14 Limited CRD, White/ Beige, ORAII, LuxII, Nav, Blk Heater, Adv Tech