Re: 4.7 big end bolt torque settings...
Head bolts, page 9-84:
"Note: The cylinder head bolts are tightened using an angle torque procedure, however, the bolts are not a torque-to-yield design." The manual also details how to check the bolts for stretch, flat edge on the threads.
Bedplate bolts, page 9-104:
The manual does not specifically state whether the bolts are TTY or not. There is a tightening procedure for three different sets of bolt. The 'main' bolts are "Tighten bolts 1-10 to 2.8 Nm (25 in lbs). Turn bolts 1-10 an additional 90 degrees."
Rod cap bolts, page 9-112:
"CAUTION: Connecting rod bolts are torque to yield bolts and must not be reused. Always replace the rod bolts whenever they are loosened or removed."
Supercharged 4.7L HO. If you would like to know more just ask.