Originally Posted by Truck.Norris
Those look awesome!! I can't wait to see yours!
Well my time table is looking like early to mid spring for me to start prototyping an intake. If i get a successful one made i will reproduce it on a very limited run. This intake is looking to be very expensive. Am already up to 223$ in it and i have yet to pick up the cf, the resins and the last few bagging materials. The cf byl itself is well into the mid to upper 200$ dollar range. I need between 16 and 20 feet of cf sleave material and the cheapest i have found is 15$ per foot for 4 inch sleave. I will adjust cost after i finish tooling up for it as i will not need to buy a vacuum pump and some supplies. Mainly just need to get cf and resins, maybe more bagging materials on each run. But still, even then just to break even it will be over 300$ but we will see.
Again, way less then ten will be made. Dont make enought to support it constantly. May even be as limited as 5 made.