Thanks for some help from 1stJeepGC, I was finally able to get everything installed, powered, and working correctly.
Started by running power down the passenger side by pulling back the carpet by the kick panel and finding the leather grommet in the midst of all the wire clusters. I ran 0gauge.
So then removed the four screws holding the passenger seat in place an disconnected the cables to the motor. You will notice a cutout in the floorboard under the passenger seat that looks like a small compartment. If you pull the top off, the battery is located there. Make sure to remove the negative post on the battery before continuing. You can then connect the fuse and secure the terminal for your amp power lead. I have big hands so it was hard working in the limited space next to the positive battery post under the hood. Well, in terms of adding the fuse and getting everything screwed together.
Sent from my iPhone using JeepGarage