Jeep Garage  - Jeep Forum banner

Mygig "Engineering Mode"

43K views 24 replies 8 participants last post by  Greeny 
#1 ·
#6 ·
Q: How do I access the MyGIG engineering menu?
A: You can access the Engineering Menu of the MyGIG by pressing the 3 Hard Keys: SEEK UP - SEEK DOWN - MENU all at the same time. Which will allow you to test your hard drive, restore the system to factory defaults, reinstall corrupt software, Screw up your MyGIG permanently, etc.. Please be VERY careful when using this menu.
 
#7 ·
+rep thanks Irfy!

So it appears that I need to update my RER...but how do i know which one to update it to????? There are so many different versions...do I want the highest-#'d one?

NOTES AND WARNINGS:

Do not turn off your radio, turn off your car, Turn off your Ignition, or start your car while the update is in progress.

For Version 2.043 - Do NOT remove the CD until after you click No on the "Update from 2.043 to 2.043" screen. See pictures.
For Version 1.295 - Do NOT remove the CD until after you click No on the "Update from 1.295 to 1.295" screen. See pictures.
For Version 1.220 - Do NOT remove the CD until after you click No on the "Update from 1.220 to 1.220" screen. See pictures.
For Version 9.807 - Do NOT remove the CD until after you click No on the "Update from 9.807 to 9.807" screen. See pictures.
For Version 9.715 - Do NOT remove the CD until after you click No on the "Update from 9.715 to 9.715" screen. See pictures.
For Version 9.713 - Do NOT remove the CD until after you click No on the "Update from 9.713 to 9.713" screen. See pictures.
For Version 9.561 - Do NOT remove the CD until after you click No on the "Update from 9.561 to 9.561" screen. See pictures.

WARNING! - Your radio will fail after installation and you will have to bring it to the dealer for repair if you don't follow the 2 above notes!

</B>Your radio will make noise while the update is being performed, Don't worry this is normal, it is just the CD-ROM spinning at high speed.
 
#15 ·
Wow new info to me! So I have a 09 MyGig with nav. That would be a RER correct? how do I get in to update?
 
#17 ·
Ok so what is this like new streets and traffic pattern in the update? Can you hack or change any settings?
 
#19 ·
$199. a year? Que? There isn't that many new streets I need to know about that bad. LOL
 
#21 ·
LOL Yeah. Does anyone else run into the nav freezing up for a few critical seconds usually when you get off the hwy and don't know what way to go. LOL
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top