Jeep Garage  - Jeep Forum banner

Part number required

2K views 7 replies 5 participants last post by  pmessling 
#1 ·
I have an early wj with the older type oil filler cap that gunks up, the hose that goes into it the 90 degree part is broken. I've repaired it a few time but keeps on breaking so ideally a replacement would be better. Does any one know the part number.

Peter
 
#2 ·
Sorry but I recommend calling your local jeep parts dealer for help. Good luck.

Ryan
 
#7 ·
It probably is the PCV valve itself, it has a small metal valve inside. It quite easily breaks of when you try to remove the attached hose when the engine is cold. The hose gets quite stiff and difficult to remove. When the hose is of, turn the valve 45 Deg ccw and pull it out.
Should be changed once in a while, because a not good working PCV can cause a lot of gunk inside your engine.
But every time when you want to remove the hose, warm it up a bit with hot water or do it on a warm engine. In this way the change to break the valve is a lot less.:thumbsup:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top