Jeep Garage  - Jeep Forum banner

GROUP BUY!!! New production of Thermal R&D 5" tips!

11K views 67 replies 17 participants last post by  psyou97 
#1 · (Edited)
I just got off the phone with Chuck at Thermal R&D and I asked him about making us some 3" inlet 5" Out x 8" Angle Cut Double Walled tips for us and they're down for it! If we can get 5 people together for 10 ten and more..... then our price will be $80.00/tip. It will take about 4 weeks for them to be made since they're kinda slammed right now. Normal price on the tip would be $99.85 and he said he'd hook us up for $80.00. It's good for me.... any other takers? Here's a pic of mine which are the same tips, but NOT angle cut. I will say that quality is top notch on these. Mirror finish and pimp looking!
And mine have been straightened since this picture for all you anal people!!:lol:

Here's the list....

1. Harrison
2. HawkMan
3. AF Maineiac
4.





 
See less See more
3
#67 ·
Ewwwwww..... they look like Pea Shooters!!:lol: Were your sections pushed all the way in? You can get them to go in more and shorten it up. Even Chris' didn't stick out that much.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top