Jeep Garage  - Jeep Forum banner

Side Moldings Swap

3K views 14 replies 6 participants last post by  Megatron 
#1 ·
Just wondering.

If I trade side moldings with a fellow jeep member, how hard/or is it even possible this can happen?
 
#2 ·
its easy.

best way is to pop off the inner door panels, you dont need all the way, just the bottom part. i was able to just pull on the bottom of the inner panel and it popped off. then you reach in and push the pins/clips holding the trim to the door, out.

thats the best way not to mess up what you have on there so you can sell.
and its not that hard. i think on one end of the front there is a small piece of t2 side tape too. but these clips/pins they just push out. its a easy job.
 
#4 ·
i never saw inside the chrome, mine are all the laredo ones. but there is not much chance or breaking them by pushing them through. more risk of breaking one if you try to pull from the outside. but from inside much better odds it will be 100% perfect.
im guessing the chrome ones have similar clips to the Laredo ones. they use the same hole.
 
#13 ·
Spare clips for ya Paul also incase Rob have trouble getting to you. Since u pass by Queens Blvd, it wouldnt be any prob for me.
Dave
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top