Jeep Garage  - Jeep Forum banner

Auto Lower Suspension On Exit

5K views 16 replies 6 participants last post by  BobsWK2 
#1 ·
Looking through my 2014 Overland manual they state an option on Settings on the Uconnect to auto lower the suspension on exit when the transmission is in Park. I looked everywhere in settings and can't see it. Just Tire Jack Mode, Transport Mode, and Wheel Alignment Mode.
Does anyone know where this setting is?
 
#2 ·
Looking through my 2014 Overland manual they state an option on Settings on the Uconnect to auto lower the suspension on exit when the transmission is in Park. I looked everywhere in settings and can't see it. Just Tire Jack Mode, Transport Mode, and Wheel Alignment Mode.
Does anyone know where this setting is?
They took it out of the 2014.:mad: Call up Uconnect Support and bitch about it!!! We're hoping they put it back in the next Uconnect update but, i'm not holding my breath.:rolleyes:
 
#4 ·
I am not sure this will be added back in. There is some logistical issues that they didn't think about when they marketed it. If you park near a curb and it auto lowers onto that curb and damages the vehicle, who's fault is that. The way Jeep sees this is if you put your own vehicle into exit and drop it onto something that is your own fault.

Ao I don't think it is going to happen.
 
#6 ·
Looking through my 2014 Overland manual they state an option on Settings on the Uconnect to auto lower the suspension on exit when the transmission is in Park. I looked everywhere in settings and can't see it. Just Tire Jack Mode, Transport Mode, and Wheel Alignment Mode.
Does anyone know where this setting is?
I also noticed that the Jack, Transport and Wheel Alignment modes aren't available either. They do nothing. :mad:
 
#15 ·
No, got home yesterday. We love traveling, but as Dorothy said, "There's no place like home". By the way, the nav worked great, even with Toronto in sight. Forgot to check Sirius/XM, used the SD card mostly.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top