Hitch Wiring Not Working?
Okay so I have searched and searched and I haven't found an answer to this yet. Hopefully I'm just not blind. Anyway I recently added the factory trailer tow and wiring to my 2013 laredo. Had no prewire to the rear so had to run full new wire. As it currently stands only running lights are working. Yes I have been to the dealer to have it activated. (or so they say). Afterwords he comes out and says I must have something hooked up wrong because all he is getting is the running lights no brake or signals. I knew that before I got there. One wire I can understand possibly getting incorrect however 3? I don't think thats possible. Now the running lights are the only ones that get tapped into so naturally they would be on however once the dealer activated it it should be working right? Any idea's? I obviously can't get into dealer connect to verify it was added and I don't personally know the tech to verify that he downloaded sales codes from dealer connect and uploaded them to my GC. Should I go to another dealer and see what they say or am I an Idiot and somehow messed this up and say forget it and get the harness that plugs into the back of the tail lights and splice them into the factory connector and have an expensive end?