Jeep Garage  - Jeep Forum banner

How to remove front bumper?? 2014 Summit

Tags
2014 summit
8K views 3 replies 3 participants last post by  kgluckman 
#1 ·
I'm looking to replace the factory upper fascia with a Trex grille and install a bull bar.

I've removed all the rivets and the 2x 10mm bolts but it still seems to be connected where the bumper meets the quarter panel.

The instructions from Dodge does not detail this step very well.

Any suggestion??

Thanks
 
#4 ·
The Summit has a trim piece over the wheel well that is taped to the body. It cover the clip at the top corner of the front fascia. You have to lift the trim piece slightly to release that clip. Unfortunately, this leaves the trim piece "unglued" at that point and you'll have to figure out a way to stick it back down.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top