Re: Cannot programme a new key - help please!!
Customer Key Programming
You can program new keys to the system if you have two
valid keys by doing the following:
1. Cut the additional Sentry Key Transponder blank(s) to
match the ignition switch lock cylinder key code.
2. Insert the first valid key into the ignition switch and
turn the ignition switch ON for at least 3 seconds but no
longer than 15 seconds. Turn the ignition switch OFF and
remove the first key.
3. Insert the second valid key and turn the ignition
switch ON within 15 seconds. After ten seconds, a chime
will sound and the SKIM indicator light will begin to
flash. Turn the ignition switch OFF and remove the
4. Insert a blank Sentry Key into the ignition switch and
turn the ignition switch ON within 60 seconds. After 10
seconds, a single chime will sound. The SKIM indicator
light will stop flashing, turn on for 3 seconds; then turn
The new Sentry Key has been programmed. Repeat this
process to program up to a total of 8 keys.
2009 Jeep Grand Cherokee SRT Design
SRT Exterior,Magnaflow 14590 w/ SRT resonators,V2 CF Medic Hood,Injen Powerflow Intake,Flying Ryan Ported TB,Custom Painted Halo Headlights,HID lows/fogs,SRT Springs,Stillens,Gloss Black SRT Reps,Mopar Spoiler, Custom Painted Moldings with Snakeskin green
GC letterings, Mopar Stripe,Tinted LED
tails/rear fogs, TLS Harness,Switchbacks, Stage6
5" Tips,Custom Door Handle Leds,5% Tint,Altec Plate,HID Reverse,Mopar Front Emblem/ Rear Logo,Powerwire,Interior Leds,RGB LED cupholders,Mygig,Weathertech Mats,LXHarness Leds,Rear Cargo Light Mod,Lockpic V4,GlossBlack Vinyl Interior Pieces